I refered to the EE-345 and thead in EZ:
https://ez.analog.com/message/121089#121089
but failed to run on ADSP-21489 EZKIT.
1) LED image programmed into on-board SPI flash, say offset 0x10000
use default boot kernel.
2) SSL image programmed into on-board SPI flash, say offset 0x0
use default boot kernel
Expect to run SSL firstly after power reset, then the customized SSL will load LED image from SPI flash and should run successful.
Attached the projects I was used for test above. Please extend your help to check what is wrong or anything missed.