I've done a bunch of work with my ADAU1761 board and now I'm ready to have my microcontroller program it. I've read the presentation/guide on how to do it from analog. My codec programs fine when I use SigmaDSP.
I built up some I2C functions to test the interface between the codec and my mcu. When I try to read a control register to verify my connection I get ACKS, but the data always comes back 0x00. But then I thought to load the codec using SigmaDSP first, and then my reads worked fine (default values shown in the datasheet were returned).
So I feel like maybe you have to do a bunch of writes to configure clock and start the processor before you can read control registers? Is that true? Is there a simple register I can read for verification? It would be nice to have a register to read that said yes this is an ADAU1761.
Thank you.
