AVES3 reads back only zeros from ADV8005

Hi,

I have the EVAL-ADV8005-SMZ and I'm using AVES3.

To connect to this board, I'm using an Aardvark and USB-to-Serial connection.

In AVES3 (with Aardvark), the read out of registers from the ADV7842 and ADV7625

goes ok. However, reading back registers from the ADV8005 results in zeros only.

Changing any register doesn't affect anything either. If I use the serial connection, I'm

able to read and write registers using the wr16 and d16 commands.

How can I get this to work? Is there maybe some additional configuration required?

Kind regards