Hi,
I would like to use the ADL5391 as a down converting mixer.
On the x input I have my measured signal which should be down converted to a fixed frequency (e.g. 10 kHz). This is a symmetrical AC signal around 0V. On the y input I have my oscillator signal which is a symmetrical AC signal around 0V too. So I want to multiply these two signals and filter the output signal and get my down converted signal at the W output. This signal should be a symmetric ac signal (around 0 V) too.
The frequency range of the x input signal is up to 10 MHz and the Amplitudes are up to 2Vp-p.
I am a little bit confused with this common mode voltage and so on, so I posted a schematic of my circuit (without the filter stage). Will this circuit fulfill the above described requirements? And will i get a symmetrical ac signal (around 0V) at the output which is X*Y?
Thanks a lot
Christoph
