I use ADIS16209 evaluation board with TI controller. I not set means not write any control register & assume that it is ok as per datasheet.
1. My target is to measure X or Y axis both side with 0.05 degree accuracy. Is it possible with this ?
2. How much delay require between 2 reading so that I get stable & accurate reading ?
3. Is any sample code or process algorithm available so that I can follow it to get me require above accuracy ?
4. I read this reading but around 4-5 bit variation occur so I reduce it ?
5. Is AVG_CNT register help me to reduce above variation or to get stability ?
In advance thanks for reply or suggestion
Jagdish