Hi Istvan,
it is written that
The osc can be enabled by doing the following:
- P200 to enable the osc
- remove R209 R210
- place C205, C206 as 0ohm resistors
- remove CR200
The performance of this oscillator is rather bad. This is because of the bad jitter performance of the on-board oscillator.
It is very difficult for me to make modification on the board means removing etc, or it will be done by putting jumpers on pins beside these resistors??. Secondly there is one more external OSC on board so can we use that and ad9517 will pass thorough this clock to ad9467?
If yes then what should be done? i read this scenario in ad9517 datasheet.
Regards,
Rohit
Message was edited by: Rohit Kumar