AD9250-FMC interposer and VC707 integration

Hi,

I recently bought AD9250-EBZ and FMC Interposer Card. My aim is to capture the signal through ADC. digitise it and send it to FPGA for filtering. However as a first step, when I try to integrate the ADC with VC707 board, as suggested by the link given below   http://wiki.analog.com/resources/fpga/xilinx/interposer/ad9250

I am not getting the desired output as mentioned in the link.

I made the board modifications for Rev B FMC interposer card in the ucf file as suggested and I tried following the steps given in the wiki link.

After I built the project through SDK and when I tried loading the FPGA, I got the following error.

Also, when I try running the download.bat, instead of getting checks on various test modes, I get the configuration details which is attached below and I am not able to capture any data though chipscope  as the device is disconnected.

Could you kindly help me out to solve this issue and point out if I am making any mistake in the setup ?

Thanks

Satheesh