Hi,
Am using AD9361 in my project. I've been trying to initialize the chip by configuring all the parameters. I happened to go through the code available online for the ML605 evaluation board.
I wish to implement the codes available for spartan 6 FPGA. I noticed that the existing code uses DDR3 RAM, Ethernet, apart from SPI, GPIOs and AD9361 Digital Interface,etc.
My question is, i wish to know if i can run the available code successfully without DDR3 and Ethernet sections from it, since my board doesn't have provisions for it.
If required, i wish to know how the DDR3 and Ethernet are contributing to the function of the AD9361 drivers in ML605.
If there's anything else that i must take care while implementing this in spartan 6, kindly let me know those too.
Regards,
howtoworkwithdevices