Hi,
I have read about the new dll for the ad5370 demo board.
Learned a lot and wrote the attached by building on the example.
This finds multiple boards and assigns i.d. When I choose board index #1 the vi executes without error but no
voltage output to channel #1. I have saved the binary val and index in the vi.
If I choose board index #2 the vi returns error writing.
Both boards work with the old dll in windows xp but only one board at a time since the old dll has no multiple board ability.
My failure occurs on a windows 7 64 bit machine running labview 2013 32 bit.
I tried running the version that works perfectly on the xp machine using the old dll on the windows 7 machine but naturally that doesn't
run because the dll is the wrong one for the the usb driver ( this is conjecture on my part)
Any ideas ???????????
Please ??????????
Dave
Message was edited by: David Persechini By the way, I tried the AD5370 evaluation software that requires hex input and this worked just fine. I used the voltage calculator to figure the base 10 values and input them as hex. The eval software predicted that correct value that was on the scope. Dave