Hi
In one PC I have installed only MATLAB 2014b and also installed libiio for 64 bit then running the model it is working.
In the PC where I am getting problems in that MATLAB 2014B ,2013a and 2011 a all are installed
So may be because of other matlab it is giving problem??? And if HIL example is working properly and on the receiver side I am adding all the correction freq oofset,phase offset,timing recovery and other .So after this what should be the next step so that we can reduce the whole setup
Exactly what I am trying to do is that I want to save or store the modulation chain (QPSK transmitter and receiver) in the FPGA part of ZED board and then instead of MATLAB I want to run the same thing from the FPGA part and then pass the modulated I and Q to RF CARD and then after receive back again when I will get I and Q values then on the receiver side processing will be done on the receiver side which is stored in FPGA .