Hi DaveD.
I was confirm the reverse operation in Eval Board (ADV7612 to ADV7511).
The reverse operation is fine.
However, it does not work where the customer has confirmed in the ADV7513.
I heard ADV7511 & ADV7513 is same chip, difference is pin connection.
I think of the connection reverse operation will become as follows. Is it correct?
----------------
0x48 bit 6 = 0 (normal)
#35 #34 #33 #32 #31 #30 ... #01 #00 ADV7511
R11 R10 R09 R08 R07 R06 ... B1 B0
#23 #22 #21 #20 #19 #18 ... #01 #00 ADV7513
R07 R06 R05 R04 R03 R02 ... B1 B0
(R11)(R10) ..... (R05)(R04) = ADV7511 bus name
----------------
0x48 bit 6 = 0 (normal)
#35 #34 #33 #32 #31 #30 ... #01 #00 ADV7511
B00 B01 B02 B03 B04 B05 ... R10 R11
#23 #22 #21 #20 #19 #18 ... #01 #00 ADV7513
-- -- -- -- B00 B01 ... R02 R03
(B00)(B01)(B02)(B03)(B04)(B05).. (R06)(R07) =ADV511 bus name
Best Regards
aimPoint